AQUA SPHERE VSP Serie Manual De Instrucciones página 16

7.4 Error code
When the device detects a failure (except for the running capacity reduction strategy and 485
communication failure), it will power off automatically and display the failure code. After pow-
er off for 15 seconds, check if the failure is cleared, if cleared, it will resume to start.
Item Error Code
1 E001
2 E002
3 E101
4 E102
5 E103
6 E104
7 E105
8 E106
9 E107
10 E108
11 E201
12 E203
13 E204
14 E205
15 E207
16 E209
Note:
1. When causes for E002/E101/E103 is displayed, the device will resume working automatical-
ly, however when it appears a fourth time, the device will stop working, to resume operation,
unplug the device and plug in & restart again.
8. MAINTENANCE
Empty the strainer basket frequently. The basket should be inspected through the transpar-
ent lid and emptied when there is an evident stack of rubbish inside. The following instruc-
tions should be followed:
1). Disconnected the power supply.
2). Unscrew the strainer basket lid anti-clockwise and remove.
3). Lift up the strainer basket.
4). Empty the trapped refuse from the basket, rinse out the debris if necessary.
Note: Do not knock the plastic basket on a hard surface as it will cause damage
5). Inspect the basket for signs of damage, replace it.
6). Check the lid O-ring for stretching, tears, cracks or any other damage
7). Replace the lid, hand tightening is sufficient.
Note: Periodically inspect and clean the strainer basket will help prolong its life.
Description
Abnormal input voltage
Output over current
Heat sink over heat
Heat sink sensor error
Master driver board error
Phase-deficient protection
AC current sampling circuit failure
DC abnormal voltage
PFC protection
Motor power overload
Circuit board error
RTC time reading error
Display Board EEPROM reading failure
Communication Error
No water protection
Loss of prime
16