Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING DETERMINATIONS
This device was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
You can install the device at any desired place in dry rooms. Please make sure that the device is not
exposed to extreme heat, moisture or dust. There should not be any cables lying around. You endanger your
own and the safety of others!
Operate the device only after having familiarized with its functions. Do not allow an operation by persons
who do not know the device well enough. Most damages are the result of an unprofessional operation!
Please consider that for safety reasons unauthorized modifications to the device are forbidden!
INSTALLATION
Procedure:
Step 1: Fix the Color-wheel-motor to the lamp housing.
Step 2: Remove the foil of the Color-wheel.
Step 3: Screw the Color-wheel onto the motor.
Connection with the mains
The electric connection must only be carried out by a qualified electrician!
In order to connect the device to the mains, you have to install a power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
Connect the device to the mains with the power-plug.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connect the device to the mains, it starts running.
DANGER TO LIFE!
International
L
N
7/14
50805090_V_1_2.DOC
Publicidad
