Hilti PR 2-HS A12 Manual De Instrucciones Original página 8

Hilti Li-ion battery type series used. Observe the information given in the section headed
Intended use.
Li-ion battery
Never use the battery as a striking tool.
Do not drop the battery. Never use a battery that has suffered an impact or is damaged in any
other way.
1.3 On the product
Laser information
1.4 Product information
products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Rotating laser
Generation
Serial no.
2 Safety
2.1 Safety instructions
2.1.1 Basic information concerning safety
Read all safety instructions and other instructions. Failure to observe the safety instructions and other
instructions may result in electric shock, fire and/or serious injury.
Retain all safety precautions and instructions for future reference. The term "electric tool" used in the
safety instructions refers to your mains-operated (corded) electric tool or battery-operated (cordless) electric
tool.
2.1.2 General safety instructions
▶ Stay alert, watch what you are doing and use common sense when operating an electric tool. Do
not use an electric tool while you are tired or under the influence of drugs, alcohol or medication.
A moment of inattention while operating the electric tool may result in serious personal injury.
▶ Do not render safety devices ineffective and do not remove information and warning notices.
▶ Keep laser tools out of reach of children.
▶ Laser radiation in excess of Class 2 may be emitted if the tool is opened without following the correct
procedures. Have the tool repaired only by Hilti Service.
▶ Laser beams should be projected well above or well below eye height.
▶ Take the influences of the surrounding area into account. Do not use the tool where there is a risk
of fire or explosion.
▶ Statement in accordance with FCC §15.21: Changes or modifications not expressly approved by Hilti
may restrict the user's authorization to operate the equipment.
2 English
Laser Class 2 based on the IEC60825-1 / EN60825-1:2007 standard in com-
pliance with CFR 21 § 1040 (Laser Notice 50).
Do not stare into beam.
PR 2-HS A12
02
2131237
*2131237*