Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Cause
The hammer drill
• Low battery.
looses efficiency.
The trigger cannot be
• The direction rotation button is in the blocking
pushed.
position.
The trigger can be
• Uncharged battery.
pushed but the
hammer drill stops
operations .
• Regulator is adjusted into a inadequate torque.
The torque regulator
stops operation.
• Small leaking can be present in extreme
The battery leaks.
temperatures or after heavy use. This is normal.
• Intense leaking or very evident shows a
damaged battery.
The battery is not
• The battery is wrongly fit into the charger.
charging and the
• The charger is not correctly plugged into the
charger light is not
power outlet.
on.
The hammer drill
• This heating is normal. It absorbs the energy
gets hot after long
from the motor cogs and the electricity
periods or work.
generated during the job.
The battery gets hot
• This heating is normal. The energy absorbed
while operating.
from the battery makes this warning.
The battery gets hot
• This type of warming is normal. Results from
while charging.
the chemical reactions happening.
The charger gets hot
• This type of warming is normal resulting from
while charging.
tension regulation.
Cleansing and care
• Keep the air vents clean and free of obstructing debris to
guarantee an adequate motor cooling.
• Regularly inspect all the assembly screws. Double check
they are correctly tightened. In the event one screw is
loose, tighten immediately.
• Use a clean and soft cloth to clean the tool. Never use
alcohol or detergent. Disconnect the tool and remove the
battery before cleaning.
Power tools and batteries should not be disposed off together with household trash. Please deliver this tool and the
batteries to its adequate recycling in the authorized disposal sites. Verify the nearest recycling center in your community.
10
ENGLISH
Troubleshooting
Solution
• Charge the battery.
• Move the direction button into the rotate or reverse
position.
• Charge battery.
• Adjust the regulator into a torque that allows the
job. Try with the next torque level.
• Immediately clean the liquid from skin or clothing
using water and soap.
• Replace the battery immediately.
• Insert correctly the battery to the charger.
• Double-check the battery is correctly connected into
the power outlet.
• Allow the hammer drill to cool off for 5 minutes.
• Stop the drill around 5 minutes to allow the battery
to cool off.
Maintenance
Service
• Servicing the tool shall be carried out only in a
• Service and maintenance carried out by non - qualified
people may result dangerous and could cause personal
damage. It also makes the Warranty void.
Environmental protection
Authorized Service Center.
Publicidad
