Publicidad
Idiomas disponibles
Idiomas disponibles
Technical Data
Code
Description
Chuck
Voltage
Functions
Speed
Strokes per minute
Rotation
Torque
Boring capacity
IP Grade
Battery
Charger
MAX-20R
WARNING
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING
Power Requirements
WARNING
Tools with double insulation and reinforced insulation are
equipped with a polarized plug (one prong is wider than the other). This plug will
only fit in the right way into a polarized outlet. If the plug cannot be introduced into
the outlet, reverse the plug. If it still doesn't fit, call a qualified electrician to install
for you a polarized outlet. Do not alter the plug in any way. Both types of insulation
eliminates the need of both a grounded third power cord with three prongs or a
grounded power connection.
WARNING
When using an extension cable, verify the gauge is enough for the power that your product needs. A lower
gauge cable will cause voltage drop in the line, resulting in power loss and overheating. The following table shows the right
size to use depending on cable's length and the ampere capability shown in the tool's nameplate. When in doubt use the
next higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
WARNING
When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are especially designed
for operating outdoors and reduce the risk of electric shock.
Hammer Drill:
Ion-Lithium 20 V
Input:
Charger power cord grips used in this product: Type "Y".
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
Before gaining access to the terminals all power sources should be disconnected.
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE
MAX-20R
101453
Cordless hammer drill / drill / driver
1/2" keyless
20 V
Hammer drill / drill / driver with 21 torque functions
Drill:
0 - 500 RPM
0 - 7 500 BPM
Forward - Reverse
Strong: 39 Nm / Soft: 8 Nm
Concrete: 1/2" | Wood: 1 1/4" | Metal: 1/2"
IP20
2 Ah | Charging time: 60 min approximately.
Voltage:
127 V
Frequency: 60 Hz
Current:
1.1 A
Tool build quality: Class III
Charger tool build quality: Reinforced insulation.
Extension gauge
from 6 ft to 49 ft
18 AWG( * )
16 AWG
14 AWG
8 AWG
MAX-20RS
101405
and
0 - 1 800 RPM
and
0 - 27 000 BPM
Output: 21.5 V
3.5 A
Authorized Service Center.
|
higher than 49 ft
16 AWG
14 AWG
12 AWG
6 AWG
grounded
ENGLISH
3
Publicidad
