Uline DEWALT H-8902 Manual Del Usuario página 6

EMPTY THE TANK
WARNING: To reduce the risk of injury from
accidental starting, unplug power cord before
emptying the dust tank.
1. Remove power head assembly of the wet/dry
vacuum by pulling outward on lid clips located
on each side of the vacuum. Lift off power head
assembly.
2. Dump tank contents into proper waste disposal
container. (See Figure 7)
Figure 7
3. Liquids may be emptied through tank drain. To
empty, turn off unit and remove plug from wall
outlet. Remove drain cap and deposit liquid waste
contents in suitable drain. After tank is empty, return
drain cap to its original position. To continue use,
plug cord into wall outlet and turn on the unit.
(See Figure 8)
Figure 8
Drain
PAGE 6 OF 21
OPERATION CONTINUED
BLOWING OPERATION
1.
2. Insert one end of the 2⁄" x 7' hose into the blowing
3. Turn vacuum "ON".
WARNING: Always wear safety goggles
complying with ANSI Z87.1 (or in Canada
CSA Z94.3) when using as a blower.
WARNING: To avoid injury to bystanders, keep
them clear of blowing debris.
CAUTION: Wear a dust mask if blowing creates
dust that might be inhaled.
CAUTION: To reduce the risk of hearing loss,
wear ear protectors when using the vacuum/
blower for extended hours or when using it in a
noisy area.
Locate blowing port on the vacuum.
port. (See Figure 9)
Figure 9
Blowing Port
0421 IH-8902