Publicidad
Idiomas disponibles
Idiomas disponibles
Routine Maintenance
• Save all instructions
C
Spark Plug:
Inspect the spark plug after every 10-15 hours of use; adjust spark plug gap and replace spark plug as necessary .
Replace spark plug every year to maintain engine performance and easy starting .
To inspect or replace the spark plug:
1 .
Remove the insulated spark plug boot .
2 .
Use the spark plug wrench to remove the spark plug,
by turning counter-clockwise .
3 .
Clean and adjust the spark plug gap to
0 .024 – 0 .028 inches (0 .6 - 0 .7 mm) .
4 .
Replace any worn plug with a recommended
replacement (see PRODUCT SPECIFICATIONS)
Clean and adjust the spark plug gap to
0 .024 – 0 .028 inches (0 .6 - 0 .7 mm) .
D
Trimmer Head:
1 . If the string retention parts become filled with debris,
they can be removed using a 5 mm hex wrench . When
reinstalling, only tighten to 5 N .m and assure the inner
part is free to move .
Storage
• Save all instructions
NOTICE
To prevent fuel gum deposits and corrosion in the
Trimmer's carburetor and fuel system, it is highly
recommended to use a fuel additive / stabilizer formulated
for ethanol fuels. Follow the stabilizer manufacturer's
instructions . Run the engine at least 5 minutes after adding
stabilizer .
1 .
Allow engine to cool and empty the fuel tank before
storing or transporting in vehicle . Use up remaining fuel
in the carburetor by starting the engine and letting it run
until it stops . Squeeze primer bulb several times to purge
fuel from the carburetor .
2 .
When not in use, store Trimmer indoors in a dry
location . Store Trimmer in a locked area out of the
reach of children .
Questions? Call Toll Free at 1-800-737-2112
5 .
Install the spark plug finger tight in the cylinder head,
then tighten firmly with the spark plug wrench .
6 .
Attach the insulated spark plug boot .
2 . If it is necessary to remove the trimmer bowl and head
note that the large retaining nut has a left hand thread
(i .e . to remove the nut turn clockwise) .
3 .
Store unit and fuel in area where fuel vapors cannot
reach sparks or open flames from water heaters,
electric motors or switches, furnaces, etc .
4 .
When preparing the Trimmer for storage or when
Trimmer will not be used for 30 days or more:
a . Inspect and clean the Trimmer thoroughly .
b . Lightly oil all external metal surfaces .
c . Remove the spark plug, place a few drops of
2-cycle engine oil into the cylinder . Pull the recoil
starter several times to distribute the oil . Replace
the spark plug .
d . Inspect and clean air filter as required .
EN-12
Copyright © 2017 MAT Engine Technologies, LLC
Publicidad
