Skil PWRCORE 12 Manual Del Propietário página 18

MAINTENANCE
WARNING
Service
WARNING
cause serious hazard. We recommend that all tool service be performed by a SKIL Factory
Service Center or Authorized SKIL Service Station.
General Maintenance
WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
Cleaning
WARNING
air. Ventilation openings and switch selectors must be kept clean and free of foreign matter.
Do not attempt to clean by inserting pointed objects through openings.
WARNING
ammonia and house hold detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep it away from corrosive
agents.
TROUBLESHOOTING
Problem
Tool does not work.
LED light rapidly
flashes
18
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
When servicing, use only identical replacement parts. Use of any
other parts could create a hazard or cause product damage.
The tool may be cleaned most effectively with compressed dry air.
Always wear safety goggles when cleaning tools with compressed
Certain cleaning agents and solvents damage plastic parts. Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
Cause
1. Battery pack charge is
depleted.
2. Tool is over-loaded.
3. Battery pack is too hot.
4. Battery pack is not installed
properly.
5. Burned out switch.
1. Tool is over-loaded.
2. Tool is too hot.
Remedy
1. Charge the battery pack.
2. Turn off the tool and then try again.
3. Turn off the tool and allow the
battery pack to cool under air flow.
4. Confirm that the battery pack is
locked and secured to the tool.
5. Have the switch replaced by an
Authorized SKIL Service Center or
Service Station.
1. Release the trigger switch.
2. Cool the tool under air flow.