Simfer IQ M7051N03N 1 Serie Manual Del Usuario página 32

2.TIMER MODE
3.ADJUSTMENT OF BUZZER TONE
NOTE: During the operation of the device, a beep sounds at every valid key press.
(*): Only available on some models.
While the device is in manual mode, timer mode is activated by
pressing the "Plus" button. Timer adjustment is made between 1
minute and 4 hours by using the plus and minus buttons in the
timer mode. Increasing and decreasing operations can be
provided by holding down the buttons. After installation, the
timer value on the screen counts down until it reaches '00'.
The timer value set for 1 hour displayed on the screen as "1h"
The timer value set for 2 hour displayed on the screen as "2h"
The timer value set for 3 hour displayed on the screen as "3h"
The timer value set for 4 hour displayed on the screen as "4h"
As soon as the established value counts down and falls below 1
minute, the remaining seconds value appears on the screen as
59, 58, 57... seconds. When the timer expires and reaches 00, the
alarm sound is activated, the relay stops transmission. The value
00 on the display also flashes in a coordinated manner with the
alarm sound. Unless any button is touched, the alarm sounds for
about 7 minutes. After 7 minutes, the alarm stops, but the
numbers '00' continue to flash on the screen. When the plus and
minus buttons are pressed at the same time, the flashing process
stops and the relay turn on the transmission. If the plus and
minus buttons are pressed together before the 7-minute period
has expired, the alarm sound will be cut, '00' numbers will be
fixed on the screen, the relay will be transmitted. If only the
minus or only the plus button is pressed while the alarm is active,
the alarm sound is cut off, the flashing operation continues.
When the device is in manual mode and the numbers '00' appear
on the screen, the buzzer tone setting is activated by holding
down the minus button for about 2 seconds. When the buzzer
tone setting is activated, the currently active buzzer tone
appears with a beep (t1,t2 or t3). Then the buzzer tone changes
(in order of t1, t2, t3, t1, t2...) in order to each minus button
pressing. To activate the selected tone, while the name of the
buzzer tone appears on the screen, it is waited for 3 seconds
without pressing any button or the tone is activated by pressing
the plus button.
32