Publicidad
Idiomas disponibles
Idiomas disponibles
Shower Arm
Assembly
Set Screw
Nut
CAUTION:
„ Product is heavy. Make sure there is adequate mounting support prior to
installation.
„ Thoroughly clean and remove debris from the water supply pipe before instal-
lation to prevent clogging the spray outlet.
„ To avoid leakage, do not move the showerhead after installation.
1) Slide the decorative flange cover and the shower flange onto the shower arm
assembly.
2) Wrap the shower arm threads with pipe tape. Screw the shower arm into the sup-
ply elbow.
3) Secure the shower flange with the self-tapping screws. Thread the decorative
flange cover onto the shower flange.
4) Install the showerhead onto the shower arm nut, then tighten it securely.
5) Secure the showerhead with the set screws.
6) Slide the decorative sleeve over the nut, then thread it onto the showerhead.
INSTALLATION PROCEDURE
Self-tapping
Wrap Pipe
Tape
Decorative Sleeve
Hex Wrench
Shower
Sprinkler Head
1/2" Clearance
Hole
Stainless Steel
Washer
Screws
Shower Flange
Decorative
Flange Cover
4
2 x 4
Brace
2 x 6
Brace
Elbow
Supply
Line
Recommended
Mounting Support
Publicidad
