Publicidad
Idiomas disponibles
Idiomas disponibles
• Open the battery port cover (15) as
described above.
• Depress the battery release button (17)
on the battery pack and pull battery
pack out of tool as shown in figure D.
BATTERY STORAGE
D
An extra battery can be stored using the
battery storage compartment (11).
• Lift the storage compartment cover and
slide the battery into the compartment
as shown in Figure E. Battery in this
compartment will not actuate the mower.
ASSEMBLY
E
This product can accept any of the batteries
and chargers listed in the chart below.
LI-ION Battery Packs and Chargers
Description
Batteries: LI-ION
Chargers: LI-ION
WARNING:
Before assembly, make
sure the bail handle is released and the
safety key is removed.
ATTACHING LOWER HANDLE
• Lift lower handle (4) into place making
sure the arrow (18) on the base of the
mower lines up with 1, 2, or 3 on the base
of the handle (19) (inset of Figure F)
17
Cat. #
LBX36
LBX1540
LBX2040
LBX2540
LBXR36
LBXR2036
LCS36
LCS40
LCS436
CAUTION:
Ensure each side of the lower
handle is set on the same number. The arrow
must be lined up with 1, 2, or 3 for operation.
• Close the handle height adjust levers
(7) as shown in Figure F. As you close
each, make sure the teeth are engaged
as shown in Figure G.
• If the connection between the handle
and lever is too tight or loose, open the
lever and adjust the depth of the lever
by turning the lever. Close it again until
the teeth are fully clasped and each
lever stays securely closed.
ATTACHING UPPER HANDLE (Figure H)
F
4
G
• Remove the upper-handle attachment
levers or knobs (5), nuts (20), and
washers (21) from the handle.
• Line up the holes on the bottom of the
upper handle (3) with the holes on the
top of the lower handle (4).
H
3
4
NOTE: Make sure the cord is located on
9
19
18
7
21
5
20
Publicidad
