5.5
DMX Mode
The DMX mode allows you to control the device with any universal DMX controller.
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
5.6
DMX Channel Values
Refer to page 3 of this manual.
6.
IR Remote Controller
BLACK OUT
Press this button to black out the current active mode. Press again to return.
AUTO
Enables you to run the automatic programmes.
1.
Press <AUTO>.
2.
Press <+> or <-> to choose the different programmes.
SOUND
Enables you to run the sound-controlled programmes.
1.
Press <SOUND>.
2.
Press <+> or <-> to choose the different programmes.
STROBE
Press this button to activate the stroboscope. Press again to de-activate.
1.
Press <STROBE>.
2.
Press <+> or <-> to adjust the strobe speed.
SPEED
Enables you to adjust the speed of the automatic programmes.
1.
Press <SPEED>.
2.
Press <+> or <-> to choose the programme.
SENSITIVITY
Enables you to adjust the microphone sensitivity.
1.
Press <SENSITIVITY>.
2.
Press <+> or <-> to adjust the microphone sensitivity.
DMX/%
Allows you to activate/de-activate the DMX mode.
MANUAL
Press this button to activate/de-activate the manual mode.
1.
Press <MANUAL>.
2.
Select your colour.
3.
Press <+> or <-> to adjust the colour intensity.
FADE
Press <FADE> to enable or disable the fader.
1-9
Press <1> to <9> to adjust the colour intensity.
V. 03 – 24/11/2017
HQLP10014
9
©Velleman nv