Publicidad
SIGNODE BXT2-10
1
2
3
Fig. 15
Fig. 16
22
5
6
4
4
3
2
1
5.9 SETTING STRAP WIDTH
The tool can be used with two different strap
widths:
7
–
9–11 mm (
/
3
– 12–13 mm (
/
1
a) Change strap width from 9 mm to 12–13 mm
– Remove battery from tool.
– Remove four cylinder screws (15/6). Lift the rocker
lever towards the handle and remove the 9 mm rear
strap stop (15/7).
– Remove cover (15/5).
– Release sunk screw (15/2) and remove 9 mm strap
stop (15/1).
– Lift the rocker lever towards the handle, release
sunk screw (15/4) and remove 9 mm strap guide
(15/3).
– Mount 13 mm strap guide (15/3) and secure sunk
screw (15/4) with Loctite 222.
– Remove oval head screw (16/4) and remove 9 mm
strap guide rear (16/3) from lever.
– Mount strap guide rear 13 mm and secure oval head
screw (16/4) with Loctite 222.
– Install cover (15/5) and secure cylinder screws (15/6)
with Loctite 222.
– Mount 13 mm strap stop rear (16/2) and secure cylin-
der screw with Loctite 222.
b) Change strap width from 12–13 mm to 9 mm
– Remove battery from tool.
– Remove four cylinder screws (15/6). Lift the rocker
lever towards the handle and remove the 13 mm rear
strap stop (16/2).
– Remove cover (15/5).
– Mount 9 mm strap stop (15/1) and secure sunk
screw (15/2) with Loctite 222.
– Mount 9 mm strap guide (15/3) and secure sunk
screw (15/4) with Loctite 222.
– Mount 9 mm strap guide rear (16/3) and secure oval
head screw (16/4) with Loctite 222.
– Install cover (15/5) and secure cylinder screws (15/6)
with Loctite 222.
– Mount 9 mm strap stop rear (16/1) and secure cylin-
der screw with Loctite 222.
")
8
")
2
01.14
Publicidad
