Publicidad
A06115001_bag.qxp_Layout 1 8/26/16 3:46 PM Page 14
HOW TO CLEAR A BLOCKAGE AND MAINTAIN POWER NOZZLE
ENGLISH
CAUTION: Always unplug vacuum cleaner
before cleaning hose or nozzle.
The vacuum cleaner may stop automatically
if the nozzle, wand, dust bag or filters
become blocked. If this happens, unplug
and allow the vacuum to cool for 20 to 30
minutes.
Clearing the wand and hose
1. Use a rod or similar blunt implement to
clear a blockage in wand or hose.
2. Sometimes an obstruction can be cleared
by squeezing or flexing the hose. Use
extreme care if there is a risk that glass,
nails or other sharp objects could be
imbedded in the hose.
Note: Warranty does not cover any damage
to the hose caused by cleaning it.
Cleaning the Power Nozzle
3. Clean Power Nozzle frequently to avoid
deterioration of suction power. Use
scissors to snip threads or hair entangled
in the brush roll, then vacuum away.
Storing and carrying
Use handle at lower front edge of canister
to carry.
1. When you pause during cleaning, park
hard floor nozzle by slipping ridges into
slot on back of canister.
2. Use alternate parking position when
vacuum is stored on end.
14
www.electrolux.com
1
2
3
1
2
Publicidad
