Publicidad
Idiomas disponibles
Idiomas disponibles
O P E R A T O R ' S
M A N U A L
Troubleshooting
Problem
Observed
Self-propel system and/or
blade do not work
LED lights do not turn on
Self-propel system stops
working during use
Blade stops working
Blade stops while pivoting
around
Blade slows
down/performance decrease
Self-propel system is too fast
or too slow for your comfort or
safety.
Revision 20221025
Possible Reason Recommended Solution
Battery not plugged in
1. Ensure the battery is placed in the mower and properly
plugged in.
2. Unplug and plug battery. Wait 15 seconds.
Main switch in wrong
Ensure the Main Switch is turned into the ON position
position
eStop Button is engaged
Ensure the Emergency Stop button is not engaged. Slightly
rotate clockwise and confirm it pops up.
Battery is depleted or not
Ensure the battery is in the mower properly and plugged in
connected properly
with a secure connection. Unplug and plug battery. Wait 15
seconds. Ensure battery is fully charged.
High Load Drive Protection
1. Let go of the control lever completely until it returns to its
may have been triggered
resting place. This will reset the self-propel system from a
high load safety stop.
2. Unplug and plug the battery, wait for at least 15 seconds.
3. Move to less inclined terrain
Blade physically stuck
Unplug and remove the battery from the mower. Inspect for
debris stuck under the cutting area. Ensure blade moves
freely
Safety Reset – The blade
1. Let go of the control lever completely until it returns to its
was momentarily under high
resting place. This will reset the blade from a high load
load
safety stop.
2. Unplug and plug the battery, wait for at least 15 seconds.
Control lever released too
When pivoting around, when slowing self-propel system,
far/training/practice
ensure the control bar is not fully released to its resting
place. There is a control lever position where the blade stays
on but the self-propel system is not engaged. This could
take practice to maintain the blade during pivoting.
Battery needs to be
Follow the instructions to replace the battery.
replaced
Wheel speed needs to be
Adjust the self-propel system wheel speed by toggling the
adjusted
speed up or down on the control panel.
21" Commercial Push Lawn Mower
Light
Status
All lights are Off
All lights are Off
All lights are On
All lights are Off
Not Applicable
Status Light
(farthest to the left)
is Red
Status Light
(farthest to the left)
is Red
All lights working
Battery Light
(farthest to the
right) is Red
Not Applicable
Page 19
Publicidad
