Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
OPERATING INSTRUCTIONS
Storage
• When your pressure washing session has been
completed, turn off the power switch located on the
front of the power washer. Unplug the power cord
from the outlet. Turn off the water supply. Pull the
trigger on the spray gun 2-3 times to drain out the
excess water and to release any remaining water
pressure. Disconnect the garden hose adapter from
the water inlet. DO NOT allow the power washer to
run with no water flowing through it.
• Remove detergent bottle and clean completely.
Residual chemical will stick to the container and can
cause the detergent injector to clog and not function
properly.
14
• Remove high pressure hose from spray gun.
• Remove lance from the gun. Place the gun in the holder
on the side. Lances are placed into any of the slots in
the back of the unit. Make sure to discard any remaining
detergent from the bottle. Flush the bottle and nozzle
head with fresh water to prevent clogging.
• Hook the power cord around the L-shaped tabs on the
right side of the machine when facing it.
Publicidad
