Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
3
B
4
I
B
1
Pull back on collar at the other end of the high pressure
hose (B). Push firmly to connect hose to spray gun (I).
Twist collar to secure. Confirm hose is locked into spray
gun by slightly pulling on them. The hose is now
securely attached to spray gun.
A
2
3
B
Soft PVC High Pressure Hose Assembly
Screw Soft PVC high pressure hose (B) clockwise
onto bottom left, when facing the unit, front of power
washer unit (A). Pull back collar and insert o-ring post
into water outlet far enough so collar can thread onto
outlet threads until hand tight. If it takes fewer than six
turns you have not properly tightened the Soft PVC high
pressure hose fitting. It is easier to position the power
washer in front of you to ensure that the threads are
started correctly. Failure to properly tighten Soft PVC
high pressure hose will result in the hose slipping or
popping off immediately upon turning unit on. Do not
worry about damage if this occurs–just reinstall and
take extra care when screwing on the Soft PVC high
pressure hose fitting.
Note: DO NOT use pliers or locking pliers to tighten.
5
I
3
B
2
Twist collar then pull back to release the the high
pressure hose (B) connection from the gun (I)
1
3
B
7
Publicidad
