Makita GHU04 Manual De Instrucciones página 13

19. Attach the chip receiver to the tool by tightening
four screws (for GHU04) or five screws (for GHU05).
For GHU04
2
Fig.26
► 1 . Chip receiver 2. Screw
For GHU05
2
Fig.27
► 1 . Chip receiver 2. Screw
NOTICE:
If the shear blades do not move
smoothly, the shear blades are not engaged with
the rods properly. Install the shear blades again.
NOTICE:
If the parts other than the shear
blades such as the rods are worn out, ask Makita
Authorized Service Centers for parts replacement
or repairs.
Removing or installing the chip
receiver
CAUTION:
When installing or removing the
chip receiver, always wear gloves so that your
hands do not directly contact the shear blades.
The chip receiver gathers discarded leaves and makes
clean-up afterward much easier.
To remove the chip receiver, remove four screws (for
GHU04) or five screws (for GHU05), and then remove
the chip receiver from the tool. To install the chip
receiver, follow the removal procedure in reverse.
1
1
For GHU04
2
Fig.28
► 1 . Chip receiver 2. Screw
For GHU05
2
Fig.29
► 1 . Chip receiver 2. Screw
OPERATION
WARNING:
blades.
CAUTION:
Avoid operating the tool in very
hot weather as much as practicable. When operat-
ing the tool, be careful of your physical condition.
CAUTION:
Be careful not to accidentally
contact a metal fence or other hard objects while
trimming. The shear blades may break and cause
an injury.
CAUTION:
Be careful not to allow the shear
blades to contact the ground. The tool may recoil
and cause an injury.
CAUTION:
Overreaching with a hedge trim-
mer, particularly from a ladder, is extremely
dangerous. Do not work while standing on anything
wobbly or infirm.
13 ENGLISH
1
1
Keep hands away from shear