Publicidad
Idiomas disponibles
Idiomas disponibles
Reverse button for debris removal
WARNING:
If the entangled branches or debris
cannot be removed by the reverse function, switch off
the tool and remove the battery cartridge, and then
remove the entangled branches or debris using tools
such as pliers. Failure to switch off the tool and remove
the battery cartridge may result in serious personal
injury from accidental start-up. Removing the entangled
branches or debris by hand may cause an injury, since
the shear blades may move in reaction to removing them.
This tool has a reverse button to change the direction
of shear blades movement. It is only for removing
branches and debris entangled in the tool.
To reverse the shear blades movement, press the reverse
button when the shear blades have stopped, then pull the
front switch trigger, and then pull the rear switch trigger
while pressing the lever. The speed indicators start blink-
ing, and the shear blades move in reverse direction.
When entangled branches and debris are removed,
the tool returns to the regular movement and the speed
indicators stop blinking and light up.
1
Fig.7
► 1 . Speed indicator 2. Reverse button
NOTE: If the entangled branches or debris cannot be
removed, release the switch triggers, then press the reverse
button, and then pull the switch triggers until they are removed.
NOTE: If you tap the reverse button while the shear
blades are still moving, the tool comes to stop and to
be ready for reverse movement.
Electronic function
The tool is equipped with the electronic functions for
easy operation.
•
Constant speed control
The speed control function provides the constant
rotation speed regardless of load conditions.
•
Electric brake
This tool is equipped with an electric brake. If the
tool consistently fails to quickly stop the shear
blades after releasing the switch trigger, have the
tool serviced at Makita Authorized Service Center.
•
Accidental re-start preventive function
Even if you install the battery cartridge while pull-
ing the switch trigger, the tool does not start. To
start the tool, first release the switch trigger, and
then pull the switch trigger.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
always wear gloves so that your hands do not
directly contact the blades.
NOTICE:
not wipe off grease from the gear and crank.
Installing or removing the shear
blades
CAUTION:
removing or installing the shear blades.
You can install 600 mm (23-5/8") or 750 mm (29-1/2")
shear blades to your tool.
NOTE: If you change the shear blades to a different
length, replace the chip receiver with one which fits
the blades.
1.
Remove four screws (for GHU04) or five screws
(for GHU05), and then remove the chip receiver from
the tool.
2
For GHU04
Fig.8
► 1 . Chip receiver 2. Screw
For GHU05
2
Fig.9
► 1 . Chip receiver 2. Screw
9 ENGLISH
Always be sure that the tool is
When replacing the shear blades,
When replacing the shear blades, do
Attach the blade cover before
1
2
1
Publicidad
