Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE:
Do not attempt to cut branches thicker
than 10 mm (3/8") in diameter with the tool. Cut
branches to 10 cm (4") lower than the cutting height
using branch cutters before using the tool.
Fig.30
► ( 1) Cutting height (2) 10 cm (4")
NOTICE:
Do not cut down dead trees or similar
hard objects. Doing so may damage the tool.
NOTICE:
Do not trim the grass or weeds while
using the shear blades. The shear blades may
become tangled in the grass or weeds.
Hold the front grip with your right hand and the rear grip
with your left hand. Pull the front switch trigger, then pull
the rear switch trigger while pressing the lever, and then
move the tool forward.
Fig.31
For basic operation, tilt the shear blades toward the
trimming direction and move it calmly and slowly at the
speed rate of 3 to 4 seconds per meter.
Fig.32
To cut a hedge top evenly, tie a string at the desired
height and trim along it.
(1)
(2)
Fig.33
The chip receiver gathers discarded leaves and makes
clean-up afterward much easier.
Fig.34
To cut a hedge side evenly, cut from the bottom to top.
Fig.35
When trimming to make a round shape (trimming boxwood or rho-
dodendron, etc.), trim from the root to the top for a beautiful finish.
Fig.36
14 ENGLISH
Publicidad
