HQ-Power HQPE10007 Manual Del Usuario página 6

3. Warranty
Refer to the Velleman
manual.
All modifications of the device are forbidden for safety reasons. Damage caused
by user modifications to the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered
by the warranty and the dealer will not accept responsibility for any ensuing
defects or problems.
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...)
arising from the possession, use or failure of this product.
Keep this manual for future reference.
4. Installation
4.1 General Guidelines
Have the device installed by a qualified person, respecting all applicable norms.
Install the device on an even, fire-resistant, scratch-resistant, water-resistant
and non-slippery surface.
The carrying construction must be able to support 10 times the weight of the
device for 1 hour without deforming.
Make sure there is no flammable material within a 1 m radius of the device.
Install the device in a location with few passers-by that is inaccessible to
unauthorised persons.
Install the device in a location where you can easily access the power cord.
Install the device in a well-ventilated area.
4.2 Overhead Installation
When hung, the device must always be secured with a secondary attachment
e.g. a safety cable.
Never stand directly below the device when it is being mounted, removed or
serviced. Have a qualified technician check the device once a year and once
before you bring it into service.
Overhead mounting requires extensive experience: calculating workload limits,
determining the installation material to be used... Have the material and the
device itself checked regularly. Do not attempt to install the device yourself if
you lack these qualifications as improper installation may result in injuries.
For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt
through the centre of the (folded) bracket.
V. 01 – 18/01/2018
HQPE10007
® Service and Quality Warranty on the last pages of this
6 ©Velleman nv