Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
AUTOMATIC CONDENSATE UNIT
NOTE：The electrical cord of the UL models is provided with a plug.
RULES FOR SAFE OPERATION
1.
Carefully read the Owners Manual and rules for safe operation.
2.
All wiring must conform to local codes. Use the National Electric Code if local code is nonexistent.
3.
CAUTION! To reduce risk of electric shock disconnect form power supply before servicing, pull the plug on models which have
plug-in connections.
4.
Do not handle the pump with wet hands or when standing in water as fatal shock could occur. Disconnect main power before
handling unit for ANY REASON!
5.
Protect the power cable from coming in contact with sharp objects.
6.
Do not kink power cable and never allow the cable to come in contact with oil, grease, hot surfaces or chemicals.
7.
Make certain that line voltage conforms to the voltage specified on motor and nameplate.
WARNING! To reduce risk of electrical shock, connect only to a properly grounded grounding type receptacle.
8.
Select a location for the pump. It should be as
near as possible to the air conditioning coil.
The pump must be level. The inlet hole must
be below the coil drain.
Carefully unpack the pump. Remove the
switch/motor cover. Check each float arm for
"free" action.
Owners Manual
Keep For Future Reference
INSTALLATION OPERATION
CAUTION: Read rules for Safe Operation and Installation.
Model: CB22
20' LIFT
Models:
CB221UL - 115V
CB222UL - 230V
CB222CE - 230V
CB222TCE - 230V
The electrical cord of the CE models does not have a plug.
INTRODUCTION
INSTALLATION
BECKETT CORPORATION
Irving, Texas
www.beckettus.com
Toll Free: 1-888-232-5388
© 2019 BECKETT CORPORATION All Rights Reserved
Derechos Reservados / Tous droits réservés
FAN
OUTLET
INLET
STAND
MOTOR
SAFETY SWITCH
PRIMARY
SWITCH
PRIMARY
FLOAT
SAFETY
FLOAT
92346 Rev. 01
Publicidad
Manuales relacionados para Beckett CB22 Serie
Resumen de contenidos para Beckett CB22 Serie
- Página 1 Carefully unpack the pump. Remove the switch/motor cover. Check each float arm for “free” action. STAND PRIMARY FLOAT BECKETT CORPORATION Irving, Texas SAFETY FLOAT www.beckettus.com Toll Free: 1-888-232-5388 © 2019 BECKETT CORPORATION All Rights Reserved 92346 Rev. 01 Derechos Reservados / Tous droits réservés...
- Página 2 APPLICATION: The warranty covers only properly installed and maintained Beckett products and is limited to application at normal temperature 32º F to 86º F, (0º C to 30º C) pumping fluids with a specific gravity up to 1.1 and with a pH range of 5 to 9 (fresh water). Other liquid applications and extreme temperature uses must be approved in advance by Beckett. The warranty does not apply to or cover damages or defects caused by external causes, including, but not limited to, improper or faulty installation or unauthorized modification, lightning, electrical surges, abuse, misuse or abnormal use or misapplication, including use in a manner inconsistent with the product’s intended function.
- Página 3 Vérifier chaque bras de flotteur Le Flotteur La Position pour s’assurer qu’elles se déplacent librement. BECKETT CORPORATION Irving, Texas Flotteur www.beckettus.com de Sûreté 92346 Rev. 01 Toll Free: 1-888-232-5388 © 2019 BECKETT CORPORATION All Rights Reserved Derechos Reservados / Tous droits réservés...
- Página 4 APPLICATION : La garantie ne couvre que les produits Beckett installés et entretenus de la façon appropriée et est limitée à l’application à la température normale de 32º F à 86º F, (0º C à 30º C) de fluides de...
- Página 5 / motor. Verifique cada brazo de la flota para la acción Flotador "libre". Primario El Soporte BECKETT CORPORATION Irving, Texas Flotador de www.beckettus.com Seguridad Toll Free: 1-888-232-5388 92346 Rev. 01 © 2019 BECKETT CORPORATION All Rights Reserved Derechos Reservados / Tous droits réservés...
- Página 6 REMEDIOS: Si ha existido una falta en la garantía, Beckett, bajo su propia discreción, optará por reparar, reemplazar, o generar un crédito o reembolso para la parte en particular disconforme. Reparar, reemplazar, acreditar o rembolsar, a criterio de Beckett, será el único remedio en el caso que no se conforme a la garantía. Los reclamos amparados por la garantía deben ser hechos dentro de los 3 meses siguientes a la expiración del Periodo de Garantía.