Carlisle Binks 83C-211-CE Manual página 7

66
67
68
69
70
65
Condition
Air escapi n g from port on
Reg ulator cap
Pressu re creepage registered on
gauge
Air leakage at Agitator seal
assembly
Air leakage from Safety Valve
below maximum working pressu re
Paint getting into bearing
assembly of agitator
Fluid or air leak at Lid Ga sket
Air Motor seized.
A. If Agitator shaft does not
turn by hand
B. If Agitator shaft turns freely,
check Air Motor
Coating material tends to settle
out rapidly
Air bubbles form in coating
material
Note: Occasionally check gauge (Ref. No. 9). The needle should return to zero with no pressure on
the gauge.
SB-E-21-042-R10 (9/2021)
Ref. 10 HAR-511 REGULATOR ASSEMBLIES
71
Service Checks
Broken or damaged diaphragm
(ref No. 71)
Dirty or worn valve seat in
regulator
Defective Seal ass embly (ref. No.
50)
The Valve seat is dirty or
damaged, or the valve stem assy
is sei z ed
Paint level in tank too high
Paint being over agitated
Defective seal assembly (Ref. No.
50)
Defective Lid Gasket (ref. No. 2)
Thumb Screws not su˜ci ently
tight
Dama ged seal assembly (ref. No
50)
Vanes (ref. No. 44) blackened or
chipped at outer edges due to a
lack of lubrication
Not enough agitation
Material being over agitated
Ref. Part No. Description
No.
65 KK-4977 Repai r Kit
+ 66 ——– "O" Ring
+ 67 ——– Spring
+ 68 ——– "O" Ring
+ 69 ——– Valve
+ 70 ——– "O" Ring
+ 71 ——– Diaphragm Assembly
Cau se
Repl a ce diaphragm
Clea n or replace valve sea t
Repl a ce Seal
Repl a ce Safety Valve. Do not
attempt to repair.
Fill tank to 50—75 mm below rim
Slow down agitator speed
Repl a ce seal
Repl a ce gasket
Tighten Scre ws
Repl a ce Seal
Repl a ce with repair kit KK-5001 -1
and refer to Air Motor Agitator
lubrication instructions
Increase Agitator speed
Slow down agitator speed
Page 7
7 / 8
EN
Individual
Parts Req.
1
1
1
1
1
1
1
Corre ction
© ITW Ltd 2007
www.carlisleft.com