Publicidad
Idiomas disponibles
Idiomas disponibles
Libra + 100m Portable chime with push/converter
Thank you for choosing this Friedland product. Please use the following instructions to
ensure correct installation and use. Keep these notes in a safe place for future reference
Checking pack contents
Unpack your chime kit and identify the
following parts:
¬ Chime
Chime bracket
Bell push/converter
CR2032 battery for bell push
2 x fixing screws for push
Bell wire (for use with a wired push)
2 x fixing screws for chime
2 x wall plugs
Adhesive pad
You will need:
A 4mm cross-head screwdriver
A small flat bladed screwdriver
A 6mm masonry drill
3 x LR6 'AA' Alkaline batteries
Quick start
The bell push supplied with this kit is pre-programmed to operate with the chime. You need to do the following to get started:
Open the bell push
Fit the push battery
Fit the chime batteries
Check the volume setting
When you operate the bell push, the chime will sound and the 1st Icon will flash. If you have additional
pushes or you want to assign a different icon to your push, you will need to follow the programming procedure.
Safety
Before proceeding with the installation,
please note the following safety warnings:
¬ Always follow the manufacturer's advice
when using power tools and wear suitable
protective equipment (e.g. safety goggles)
when drilling holes etc.
¬ Before drilling holes in walls, check for
hidden electricity cables and water pipes,
the use of a cable/pipe locater maybe
advisable if in doubt.
¬ When connecting the landscape
push/converter to other manufacturers'
equipment, check manuals and if necessary
consult the manufacturer regarding suitability
for the intended use.
2
.
Publicidad
