FRIEDLAND D912S Manual De Instrucciones página 4

Open the bell push/converter
remove nameplate
Using a ball point pen press at point A shown in fig 1
Remove the name plate. If desired, you can prise
apart the two halves of the name plate and write on
the card. Undo the retaining screw B and remove
the back of the push.
A
To fit the push/converter battery
Insert the CR2032 coin cell. Ensure the face
marked '+' is uppermost (Fig. 2).
Fig. 2
Fig. 1
B
Fit the chime batteries
To remove the chime battery cover, press at
point C and slide the cover back 5mm then lift
off. Insert 3 x LR6 'AA' Alkaline batteries (not
supplied). Observe polarity as marked inside
the battery compartment (Fig. 3).
Fig. 3
C
3