To assure maximum performance of the EdenPURE
the following recommendations:
1) For best result, do not locate the heater in an area with a high rate of
air filtration and movement as the warm air will be exhausted.
2) Try placing the heater near a warmer inside wall and direct the output
towards a cooler outside wall. The cooler outside wall will tend to
draw the generated heat towards itself, which will allow for more effi-
cient heating.
3) Placing the heater next to a cold air return will draw the heat away
from area to be heated. Try closing or covering the cold air return.
This will allow for more efficient heating. Experiment with the place-
ment of the heater to see what works best for you.
4) To ensure maximum efficiency, a 40% (minimum) relative humidity
should be maintained in the heated environment.
5) The heaters are designed to operate for maximum efficiency up to 70-
72 degree range. due to the soft heat concept, a temperature of 68 de-
grees will feel as though it were 72 degrees. This is due to the heat
mixing evenly with humidity for "head-to-toe" comfort.
6) when the heater is placed in an isolated area, i.e. basement or recre-
ation area, the delivery registers and air return grills of the
existing system should be closed in that area if possible.
7) Try placing the heater a few feet above the floor in rooms with large
areas of bare concrete. Make sure the heater is secure and won't fall.
This will allow for more efficient heating since concrete acts as a heat
sink and will tend to draw the heat its direction.
8) Try lowering your central heating system to a lower temperature and
placing the heater in the area you spend the majority of your time.
Now set the EdenPURE
is no point to heating multiple rooms to 68+ degrees when they are not
in use.
9) when heating larger areas, place the heater in a central location. If a ceiling
fan is nearby, try using it at the same time to help distribute the heat evenly.
Our suggestion, give it a try and see what works best for you.
10) If used in an extremely dirty or dusty area, the filter must be cleaned
more frequently as it can clog and cause the heater to stop working.
11) The heater grill is hot when in use. To avoid burns, do not let bare skin
touch hot surface. If provided, use handles when moving this heater. Keep
combustible materials, such as furniture, pillows, bedding, papers, clothes,
and curtains at least three feet from the front of the heater and keep them
away from the sides and rear.
12) Extreme caution is necessary when any heater is used by or near children or
invalids and whenever the heater is left operating and unattended.
13) To disconnect heater, turn controls to "off", then remove plug from outlet.
14) Always unplug heater when not in use.
Performance Suggestions
®
heater to your comfort level. After all, there
7
Heater, please note
®