Publicidad
Idiomas disponibles
Idiomas disponibles
6. Installation of Fan.
Tip: Seek the help of another person to hold
the stepladder in place and to help lift the fan
up to you once you are set on the ladder.
Remove set screw at bottom of fan assembly.
With the wall bracket secured to the wall and
able to support the fan, you are now ready to
hang the fan.
Connect 4-wire plug from inside of fan
assembly to 4-wire plug from wall. Be sure
molex connections snap together securely.
Grab the fan firmly with two hands. Align the
4 slots in the middle of the back of the fan
assembly with the 4 hooks on the wall bracket
and then pull down firmly on fan assembly.
WARNING: Make sure that all 4 hooks on the
wall bracket have engaged completely with
the 4 slots in the fan assembly and that the
fan assembly is stable.
Replace set screw at bottom of wall
bracket--be sure to securely tighten set
screw.
7. Wall Control Operation.
turns fan to LOW speed
-
turns fan to MEDIUM speed
-
turns fan to HIGH speed
-
(slider switch in
fan OFF
-
lowest position)
ON/OFF switch
turns oscillation ON/OFF
-
fan assembly
slots
set screw
page 7
wall
hooks
bracket
molex
connections
Publicidad
