Onkyo NS-6170 Manual De Instrucciones página 5

> Before Start > Part Names
Rear Panel

1. AC INLET: Connect the supplied power cord.
2. Wireless antenna: Used for Wi-Fi connection. Adjust their angles according to the
connection status.
3. AUDIO OUTPUT DIGITAL OPTICAL jack: Connect a pre-main amplifier with digital optical
cable.
4. AUDIO OUTPUT DIGITAL COAXIAL jack: Connect a pre-main amplifier with digital
coaxial cable.
5. ETHERNET jack: Connect to the network with an ethernet cable.
6. USB port: Connect a USB storage device or HDD (hard disk drive) to play music files. You
can also supply power (maximum 5 V/1 A) to USB devices with a USB cable.
7. AUDIO OUTPUT ANALOG jacks: Connect a pre-main amplifier with the included analog
audio cable.
8. REMOTE CONTROL jack: Connect an Onkyo product with an RI jack using the
included RI cable to synchronized with this unit. (
9. ANTENNA DAB/FM jack: Connect the included DAB/FM wire antenna.
4
> Install > Initial Setup
  
 
P8)
> Playback

 
Advanced Setup | Firmware Update | Others

90°
180°
E
N