Publicidad
Idiomas disponibles
Idiomas disponibles
3. PREPARING TO USE THE BOOSTER
IMPORTANT: AFTER PURCHASE,
CHARGE YOUR BOOSTER FOR
24 HOURS, BEFORE USE.
WARNING! RISK OF CONTACT WITH
BATTERY ACID. BATTERY ACID IS A
HIGHLY CORROSIVE SULFURIC ACID.
3.1 Be sure the area around the battery is well
ventilated while the booster is being used.
3.2 Clean the battery terminals before using
the booster. During cleaning, keep
airborne corrosion from coming into
4. BOOSTER LOCATION
WARNING! RISK OF EXPLOSION
AND CONTACT WITH BATTERY ACID.
4.1 Locate the booster as far away from the
battery as the DC cables permit.
4.2 Never place the booster directly above
5. INSTALLATION INSTRUCTIONS
5.1 Remove all cord wraps and uncoil the cables
prior to using the charger and booster.
6. FEATURES
1
2
6.11 Charger LED Indicators
POWER (green) LED lit: The
charger is connected to AC power.
CHARGING INDICATOR
Yellow/orange LED lit: The charger
is charging the battery.
Yellow/orange LED flashing:
The charger is in abort mode.
Green LED pulsing: The battery
is fully charged and the charger
is in maintain mode.
3
4
5
contact with your eyes, nose and mouth.
Use baking soda and water to neutralize
the battery acid and help eliminate
airborne corrosion. Do not touch your
eyes, nose or mouth.
3.3 Determine the voltage of the battery by
referring to the vehicle owner's manual
and make sure that the output voltage of
the booster is correct.
3.4 Make sure that the booster cable clamps
make tight connections.
the battery being jumped; gases from
the battery will corrode and damage the
booster.
4.3 Do not operate the booster in a closed-in
area or restrict the ventilation in any way.
5.2 After purchase, charge your booster for
24 hours, before use.
1. Battery clamps
2. Circuit breaker for
12V DC power output
and charge port
3. 12 Volt DC power outlet
and charge port
4. Voltmeter button
7
8
CLAMPS REVERSED (red)
LED flashing: The connections
are reversed.
BAD BATTERY (red) LED lit:
The charger has detected
a problem with the battery. See
Troubleshooting for more information.
• 6 •
5. Voltmeter
6. Auxillary charging port
(on back; not shown)
7. SC2DSR charger
8. Charging status LED
9. Power LED
10. 12V DC adaptor
(not shown)
9
Publicidad
