Workshop WS1600VA0 Manual Del Propietário página 5

SP6820-2 Workshop 2018.qxp_WS1200VA0 WS1600VA0 7/20/18 1:56 PM Page 5
cAsTeR/cAsTeR fooT AssemblY
With the Powerhead Assembly removed
from the Drum, and the Drum upside
down on the floor:
1. Insert the 4 Caster Feet into the
bottom of Drum, as shown on the
4 locations.
2. Push firmly on the Caster Foot until
the Foot is flush with bottom of the
Dust Drum.
3. Insert the Caster Stem into the Socket
of the Caster Foot, as shown
(4 places).
4. With a slight twisting motion, push on
the Caster until the Ball on the Caster
Stem is inserted all the way into the
Socket. You will hear the Ball snap
into the Socket and the Caster will
swivel easily when positioning is
correct.
5. Turn the Drum upright.
1. Line up front of Powerhead Assembly
with Vacuum Inlet located on the front
of the Drum, as shown.
2. Place Powerhead Assembly on top of
Drum.
3. Be sure Powerhead Assembly
completely covers the top of the Drum
so leakage does not occur.
4. Push down on top of the Drum Latch
areas to cause the Flexible Locking
Tabs to hook onto the Drum Channel.
5. Make sure that the Locking Tabs are
snapped in place to prevent the
Powerhead Assembly from coming off.
(See inset).
WeT/DRY vAc AssemblY
Caster
Foot
Hole
Dust
Drum
Ws1200vA0
Out
Flexible
Locking Tab
Push Down
5
Caster
Caster Stem
Caster Ball
Pin
Drum
Top
Assembly
Push Down
Pull Out
Flexible
Locking
Tab
Drum
Channel