Publicidad
Idiomas disponibles
Idiomas disponibles
• This product is for use indoors.
• A mounting bracket compliant with VESA specifications is
required.
• Since the monitor is heavy, consult your dealer before
installing, removing or moving the monitor.
• Mounting the monitor on the wall requires special expertise
and the work must be performed by an authorized SHARP
dealer. You should never attempt to perform any of this
work yourself. Our company will bear no responsibility
for accidents or injuries caused by improper mounting or
mishandling.
• Use the monitor perpendicular to a level surface. If
necessary, the monitor may be tilted up to 20 degrees
upward or downward.
• When mounting the monitor horizontally, the optional fan
cover (PN-ZR31) is required. For details along with the
horizontal mounting conditions, consult your dealer.
• This monitor should be used at an ambient temperature
between 32°F (0°C) and 104°F (40°C). Provide
enough space around the monitor to prevent heat from
accumulating inside.
For the monitor in
landscape orientation
2
[5]
For the monitor in
portrait orientation
7-7/8
[20]
2
[5]
2 [5]
• If it is difficult to provide sufficient space for any reason
such as the installation of the monitor inside a housing, or
if the ambient temperature may be outside of the range
of 32°F (0°C) to 104°F (40°C), install a fan or take other
measures to keep the ambient temperature within the
required range.
• Temperature condition may change when using the monitor
together with the optional equipments recommended by
SHARP. In such cases, please check the temperature
condition specified by the optional equipments.
• Do not block any ventilation openings. If the temperature
inside the monitor rises, this could lead to a malfunction.
• Do not place the monitor on a device which generates heat.
4
E
MOUNTING PRECAUTIONS
Unit: inch [cm]
1-3/8 [3.5]
7-7/8 [20]
2
[5]
2 [5]
Unit: inch [cm]
1-3/4 [4.5]
2
[5]
• Adhere to the following when installing the monitor in its
portrait orientation. Failing to adhere to the following may
cause malfunctions.
- I nstall the monitor such that the power LED is located on
the bottom side.
- Set the MONITOR on the SETUP menu to PORTRAIT.
(See Operation manual.)
- B e sure to secure the power cord (supplied) to the cable
clamp attachment with the supplied cable clamp. Make
sure that the power cord (supplied) does not supply power
to the terminal when being secured and do not over bend
the power cord (supplied).
• Use the supplied vertical sticker when you install the
monitor in portrait orientation.
Operation panel
- Do not remove the factory-affixed sticker but affix the logo
sticker over it. Be careful not to cover the remote control
sensor or buttons.
• After installing the monitor, affix the included protection
covers as necessary, and then apply the included protection
stickers.
Power cord (Supplied)
Cable clamp attachment
Cable clamp
Logo
1. Protection
cover
2. Protection
sticker
Publicidad
