Pleasant Hearth OFG012T Manual De Instrucciones página 11

ASSEMBLY INSTRUCTIONS
1. Attach the bottom plate (J) to the left and right side
panels (F and M) with four M6X12 bolts (AA) as
shown on figure 1. Make sure the center ring on the
bottom plate (J) is positioned closer to the
magnet side of left side panel (F). Tighten with
Phillips screwdriver (EE). The configuration as
pictured is upside down. Keep the unit in this
position.
Hardware Used
AA
Bolt M6 X 12
EE
Phillips screwdriver
2. Screw the four feet (N) into the bottom of the left and
right side panels (F and M) as shown on figure 2.
3. Turn the unit upright. Attach the back panel (L) to
the left and right side panels (F, M) with four M6X12
bolts (AA) as shown on figure 3. Tighten with Phillips
screwdriver (EE).
Hardware Used
AA
Bolt M6 X 12
EE
Phillips screwdriver
1
F
X 4
2
F
3
F
X 4
11
AA
AA
Magnet
M
J
M
AA
L
M
N