Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
The maximum inlet gas supply pressure: 250 psi /1750 kPa.
Place a dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of
dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or
plugs may result in leakage of propane.
DO NOT obstruct the flow of combustion air and ventilation air to the fire pit.
The propane cylinder must be arranged for vapor withdrawal and equipped with a listed overfilling
prevention device. Please use the proper cylinder orientation to provide vapor withdrawal.
NOTE: The cylinder must be fully upright for the cylinder to have vapor withdrawal only.
Vapor
Liquid
CORRECT
a. Do not store a spare LP-gas cylinder under or near this appliance.
b. Never fill the cylinder beyond 80 percent full.
c. If the information in (a) and (b) is not followed exactly, a fire causing death or serious injury
may occur.
The pressure regulator and hose assembly supplied with the appliance must
be used. The installation must conform with local codes, or in the absence of
local codes, with national fuel gas code, ANSI A223.1/NFPA54, natural gas
and propane Installation Code, CSA B149.1, or propane storage and handling
code, B149.2.
13. Before connection, be sure that there is no
debris caught in the outlet of the gas cylinder,
inlet of the regulator valve or in the outlet
of the burner and burner ports. Ensure the
propane cylinder valve is turned off. Then
connect the gas cylinder with the regulator (Q)
as shown in figure 13. Fix the gas cylinder in
place by tightening the butterfly bolt.
Vapor
Liquid
WRONG
CAUTION
13
17
Vapor
Liquid
WRONG
Q
J
Butterfly Bolt
J
Publicidad
