Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Turn the base assembly upside down. Insert the
valve stem on the burner assembly (C) into the
square hole on the left side panel (F). The regulator
assembly (Q) must remain inside the base assembly
during installation. DO NOT let the base assembly
press into the regulator assembly (Q) during
installation. Attach the base assembly to
the table (D) with four M6X12 bolts (AA) as shown in
figure 7. Tighten with screwdriver (EE)
Hardware Used
AA
Bolt M6 X 12
EE
Phillips screwdriver
8. Attach the control panel (G) to the left side panel
(F) with two M5X8 screws (CC). Tighten with
screwdriver (EE). Then attach the control knob (P)
to the control panel (G) as shown in figure 8. Turn
the control knob (P) to the "OFF" (o) position
as illustrated below.
Hardware Used
CC
Screw M5X8
EE
Phillips screwdriver
Figure a
Figure b
7
F
X 4
8
P
Figure c
X 2
13
C
G
F
Normal
AA
Q
D
CC
in.
in.
in.
Abno
Publicidad
