Lamborghini Caloreclima EM 16-E Manual Para La Instalacion Y El Mantenimento página 26

GENERAL INSTRUCTIONS
• This booklet constitutes an integral and essential part of the product and should be sup-
plied to the installer.
Read carefully the instructions contained in this booklet as they provide important directions
regarding the safety of installation, use and maintenance.
Preserve this booklet with care for any further consultation. The installation of the burner
must be carried out in compliance with current regulations, according to the instructions
of the manufacturer and by qualified personnel. An incorrect installation can cause injury
or damage to persons, animals and objects, for which the manufacturer cannot be held
responsible.
• This appliance should be destined only for the use for which it has been expressly envisa-
ged. Any other use is to be considered improper and therefore dangerous. The manufactu-
rer cannot be considered responsible for any damages caused from improper, erroneous or
unreasonable use.
• Before carrying out any cleaning or maintenance operation, disconnect the appliance from
the power supply, by using the main system switch or through the appropriate interception
devices.
• In case of failure and/or malfunctioning, switch off the equipment and refrain from trying any
repair or direct intervention. Call in qualified personnel only. Any repair must be carried out
by a servicing centre authorised by the manufacturing firm, one using original replacements
exclusively. Non-observance of the above could compromise the safety of the appliance.
In order to guarantee the efficiency of the appliance and its proper operation it is indispen-
sible to keep to the manufacturer's directions, by ensuring the periodical servicing of the
appliance is carried out by professionally qualified personnel.
• As soon as one decides not to use the appliance further, one should take care to render
innocuous those parts liable to be potential sources of danger.
• The transformation from a gas (natural gas or liquid gas) to a gas of another group must be
made exclusively by qualified personnel.
• Before starting up the burner for the first time ask qualified personnel to check:
a) that the data on the information plate corresponds to that required by the gas, and electri-
cal supply networks;
b) that the calibration of the burner is compatible with the boiler output;
c) that the comburent air flow and the fumes evacuation take place properly in accordance
with the regulations in force.
d) that correct aeration and maintenance are possible.
• After each reopening of the gas cock wait a few minutes before restarting the burner.
• Before carrying out whatever intervention which foresees the dismantling of the burner or
the opening of any of the accesses for inspection, disconnect the electrical current and
close off the gas cocks.
• Do not deposit containers of inflammable substances in the location where the burner is
UK
situated.
26
M U