Programming Functions; Setting Frequency - Telcoma Automations SAFETY RADIO CONTACT Manual De Uso

GB

PROGRAMMING FUNCTIONS

The transmitter can be programmed in such a way that it activates
the COSTA 2 ("EDGE2") output on the receiver. It is also possible to
cancel one or all of the transmitters from the receiver.
These functions are shown in the table below.
NUMBER RX LED
OF TIMES FLASHES
1* 1
2* 2
3 3
4 4
10 sec** fixed light
* If the transmitter is already present in the receiver memory, the
buzzer will emit a repeated sound.
** Hold down button Pr1 for at least 10 seconds until the LED
remains illuminated steadily for a few seconds.

SETTING FREQUENCY

If a number of receivers are installed within a radius of 100 m, it is
advisable to set the receivers, and consequently the transmitters,
for operation on different frequencies.
To select the frequency, set dip-switches numbers 1 and 2 (2 in Fig.
4 and 1 in Fig. 7) according to tables TAB1 and TAB2.
32
FUNCTION
memorisation on COSTA1 ("EDGE 1")
memorisation on COSTA2 ("EDGE 2")
no function
cancellation of single transmitter
total cancellation of transmitters (RESET)