Publicidad
Idiomas disponibles
Idiomas disponibles
[Main unit]
CAUTION
• When storing or carrying the tool, set
the Forward/Reverse lever to the
center position (switch lock).
NOTE:
Exercise caution to ensure no objects
come into contact with the tool's
trigger switch.
If an object comes into contact with
the tool's trigger switch, even while
the Forward/Reverse lever is in the
center position (locked), a small
amount of electric current may
continue flowing, which may cause an
excessive discharge from the battery
pack and subsequent battery pack
failure.
Switch and Forward/Reverse Lever
Operation [Fig.5]
1. Push the lever for forward or reverse
rotation. Check the direction of the
lever before using.
2. Depress the trigger switch slightly to
start the tool slowly.
3. Speed will increase by pressing the
trigger. The tool stops working immedi-
ately by releasing the trigger.
4. When done with an application, lock the
switch by centering the lever.
NOTE:
When the brake operates, a braking
sound may be heard. This is normal.
CAUTION:
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not
signal a malfunction.
* This lag occurs as the tool's circuitry
starts up when the trigger is pulled for
the first time after installing a battery
pack or after the tool has not been
used for at least 1 minute (or at least
5 minutes when the LED is on).
Rotation will start without any lag
during second and subsequent opera-
tions.
CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit
comes to a complete stop.
Clutch Torque Setting
Adjust the torque to one of the 18 clutch
settings or " " position.
CAUTION:
• Set the clutch setting at this mark
[Fig.6] before actual operation.
• If the clutch handle cannot be set at
"drilling" mode after driving with clutch
function, set the clutch handle at
position 1 and operate the clutch for a
second.
Speed Selection
Choose a low or high speed to suit the
use. [Fig.7]
The more the variable speed control
trigger is pulled, the higher the speed
becomes.
CAUTION:
• Check the speed selector switch
before use.
• Use at low speed when high torque is
needed during operation. (Using at
high speed when high torque is
required may cause a motor break-
down.)
• To prevent excessive temperature
increase of the tool surface, do not
operate the tool continuously using
two or more battery packs. The tool
needs cool-off time before switching
to another pack.
• Do not close up vent holes on the
sides of the body during operation.
Otherwise, the machine function is
adversely affected to cause a failure.
• Do NOT strain the tool (motor). This
may cause damage to the unit.
• Use the tool in such a way as to
prevent the air from the body vent
holes from blowing directly onto your
skin. Otherwise, you may get burned.
- 11 -
EN
Publicidad
