Publicidad
Idiomas disponibles
Idiomas disponibles
Indicator
3 lamps
illuminated
2 lamps
illuminated
One lamp
illuminated
3 lamps
flashing
Battery level indication is just guide.
The indication may change due to the
condition of battery or ambient tempera-
ture.
Excessive (complete) discharging of
lithium ion batteries shortens their service
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
Bit-locking Function
1. With the trigger switch not engaged and
a screwdriver bit locked in place, the
tool can be used as a manual screw-
driver (up to 22.6 N•m, 230 kgf•cm, 199
in•lbs).
There will be a little play in the chuck,
but this is not a malfunction.
2. This feature is handy for tightening
screws that require more torque than
the maximum torque of the driver
(position
on the clutch), for confirm-
ing the tightness of a screw or to loosen
an extremely tight screw.
Battery status
Charged
enough
Approx. 60%
remaining
Battery level is
low.
Need to be
charged soon
Empty
Need to be
charged imme-
diately
- 13 -
Changing the Belt Hook Location Side
[Fig.8]
The belt hook can be attached to either
side of the unit.
1. Removing the hook
(1) Remove the nut.
(2) Draw out the hook.
2. Attaching the hook to the other side
(1) Insert the hook in the other side.
(2) Tighten the nut fully so that it
securely fastened.
WARNING!
• Be sure to attach the belt hook securely
to the main unit with the screw firmly
fastened. When the belt hook is not
firmly attached to the main unit, the
hook may disconnect and the main unit
may fall.
This may result in an accident or injury.
• Periodically check screw for tightness.
If found to be loose, tighten firmly.
• Be sure to attach the belt hook firmly
and securely onto a waist belt or other
belt. Pay attention that the unit does
not slip off the belt. This may result in
an accident or injury.
• When the main unit is held by the belt
hook, avoid jumping or running with it.
Doing so may cause the hook to slip
and the main unit may fall.
This may result in an accident or injury.
• When the unit is hooked onto the waist
belt by the belt hook, do not attach
driver bits to the unit. A sharp edge
object, such as a drill bit, may cause
injury or an accident.
EN
Publicidad
