Publicidad
Fig.2
a. Attach the part(#15) to the part(#1) using (4)M6*20 Hex Bolts(#31).
b. Set the part(#14) to the shaft of part(#1), and then attach the part(#16) to the part(#14) using (4)M6*40 Hex
Bolts(#32).
c. Insert the 25*25 Plug(#21) into the part(#14).
d. Insert theφ22 Plug(#24) into the part(#6), and then insert the part(#6) through the part(#2)..
Fig.3
a. Insert the part(#11,#12) through
the part(#2) and attach them using
(2)M6 Nylon Lock Nut(#13)
respectively.
FYTTER |WWW.FYTTER.COM
PAG- 13
Publicidad
