Publicidad
Assembly & Set-Up
Contents of Carton
•
One Hauler Assembly
•
One Hardware Pack
NOTE: All references to LEFT, RIGHT, FRONT, and REAR indicate
the hauler position when seated in the tractor's operator seat
and facing forward.
Hardware Pack
1
2
3
The contents of the hardware pack are listed below and
referenced in Figure 3-1.
1.
Two (2) Flat Washers, .760 x 1.490 x .060 (736-0351)
2.
Two (2) Flange Washers, .781 x 1.590 (736-04228A)
3.
Two (2) Lynch Pins, .1875 (714-0220A)
4.
One (1) Lithium Grease (737-04085)
6
•
One Tongue Assembly
•
One Operator's Manual
4
Figure 3-1
•
Two Wheel Assemblies
Hauler Preparation
1.
Carefully unpack the contents of the carton and unwrap
and cut any cable ties securing the contents in the carton.
2.
Carefully stand the hauler up as shown in Figure 3-2.
Figure 3-2
3.
Before installing the wheels, the axles and the inside of the
rims should be greased with the packet of grease shipped
with your hauler. Approximately half of the package should
be used on each side. Apply some grease to the exposed
portion of the axle and coat the axle completely. Squeeze a
small amount of grease into the rim.
3
Publicidad
