GRE AR1020W Manual De Instrucciones página 4

INSTALLATION
1. Drill holes in the concrete floor or other solid ground, fix the solar shower to the ground by the
bolts in the parts bag, and make sure the solar shower will not collapse due to the strong wind
and other external forces.
2. It is much better to install the solar shower in the places where the sunshine will last much
longer than others. It could help to have the right temperature of water while in use.
3. Quick connect adaptor is used for the water inlet. We suggest using the flexible hoses. Make
sure this flexible hose would bear the pressure of 6kgs/cm
4. Please ask professionals to install the solar shower to avoid any injury.
5. Have a testing after all the components are installed to check whether there are leaking
problems. Transportation and any improper operation during installation will make the parts
loose thus cause leaking. Tightly screw the leaking part may help solving the leaking problems.
NOTES
1. When the sunshine is strong, especially in summer, the water inside the tube will reach a very
high temperature, so please do not stand under the solar head when you use it. Otherwise you
will be scalded by the hot water, please turn on the cold water first then adjust the water
temperature by the handle gradually.
2. Do not remove or add any parts, otherwise leaking would be easily caused.
3. Clean the shower head periodically to make sure the water sprays without resistance.
4. Children are not allowed to use the solar shower alone.
5. Fill up the tube after the shower is installed. You should turn the adjusting handle to the
position of hot water, when the shower head have water spray, the tube is fully filled
The foot shower does not have hot water.
Turn on the cold water first then adjust the water temperature by the handle gradually.
Flowing pictures show you the hot and cold water handle position, Turn to blue side, it is
cold water, and turn to red side, and it is hot water.
2
.
- 2 -