Publicidad
Idiomas disponibles
Idiomas disponibles
EN
USE
These jacks operate according to the hydraulic principle and have been
specially designed for tyre changes, where they are widely used on cars
and tractors.
The jacks are only suitable for lifting operations. The ambient temperature
in which the jacks are used must not exceed +50°C or fall below -20°C.
They should not be used in areas in which acids, alkalis or corrosive gases
are present. The jacks may not be used in extreme conditions (extreme
climate, use in deep-freeze areas, strong magnetic fields) or in potentially
explosive atmospheres.
Always use the jacks in accordance with operating instructions.
The jack may be used for short-term lifting operations in private settings.
Do not use in damp environments. Protect against mechanical influences.
Not suitable for use on construction sites.
This jack complies with the EN 1494 +A1:2008 standard for mobile or
movable jacks and associated lifting equipment, as well as European
Directive 2006/42/EC ("Machinery Directive").
SAFETY INFORMATION
• Never use under extreme conditions, e.g. in extreme climate
zones, deep-freeze applications, strong magnetic fields, etc.
• Never use in special fields of application: e.g. potentially
explosive areas, mines, etc.
• Never lift loads whose state (molten metal, acids, radioactive
materials, brittle loads, etc.) could lead to a hazardous
situation occurring.
• Hazards can occur during decommissioning – this should be
carried out by an expert.
• For use indoors only to avoid the risk of wind pressure during
and outside of the operation.
• Never use on vessels, particularly sea-going vessels.
• Oil must not leak during use. If an oil leak is detected,
discontinue use immediately and contact the manufacturer.
• In the event an obstruction, discontinue use immediately
and support the load with an ordinary stand. Contact the
manufacturer for assistance.
32
USER MANUAL
Publicidad
