Philips QT4005 Manual De Usuario página 5

general
- The appliance is equipped with an automatic voltage selector and is
suitable for mains voltages from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe low voltage of less than
24 volts.
charging
Charge the appliance fully before you use it for the first time or after a long
period of disuse.
It takes approximately 10 hours to fully charge the appliance.
When it is fully charged, the appliance has a cordless operating time of up
to 35 minutes.
Note: For safety reasons, the epilator can only be used cordlessly. Make sure
the appliance is charged before use.
1 Make sure the appliance is switched off.
2 Insert the appliance plug into the appliance.
3 Put the adapter in the wall socket.
, The charging light on the adapter lights up green continuously to
indicate that the appliance is charging.
Note: The charging light on the adapter does not change colour and does not
go out when the appliance is fully charged.
4 After charging, remove the adapter from the wall socket and pull the
appliance plug out of the appliance.
optimising the lifetime of the rechargeable battery
When you have charged the appliance for the first time, we advise you to
use it until the battery is completely empty. Continue to use the appliance
until the motor almost stops running during a session. Then recharge the
battery. Follow this procedure at least twice a year.
using the appliance
Always comb the beard and/or moustache with a fine comb before you
start trimming.
When you trim for the first time, be careful. Do not move the trimmer
too fast. Make smooth and gentle movements.
Trimming with comb
1 Turn the Precision Zoom Lock™ adjustment ring to the
desired setting. The selected setting is the setting in the centre of the
adjustment ring.
See the table below for an overview of the settings and the resulting hair
lengths.
English
5