Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
I cannot select a 6V or
12V setting.
Green LED is solid
and the display shows
ANALYZING BATTERY.
Green LED is flashing
and the display shows
CHARGE ABORTED-
BAD BATTERY.
The display shows
CONNECT CLAMPS.
16. SPECIFICATIONS
Input Voltage ................................................................120V AC @ 60Hz, 0.91A
Output Voltage .......................................6V or 12V, with Auto Voltage Detection
Output Current Rating ..........................................................2A @ 6V; 3A @12V
17. REPLACEMENT PARTS
Battery clamps (quick-connect) ..................................................... 3899002636Z
Ring connectors (quick-connect) .................................................. 2299002042Z
12V accessory plug (quick-connect) ............................................. 3899001401Z
18. BEFORE RETURNING FOR REPAIRS
or call 1-800-621-5485, Monday-Friday 7:00
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO
NOT SHIP UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION
(RMA) number from Customer Service at Schumacher Electric Corporation.
POSSIBLE CAUSE
The charger is equipped with
Auto Voltage Detection, which
automatically detects the voltage
and charges the battery.
The charger needs to check the
condition of the battery.
The battery is sulfated.
The battery is too large for the
charger.
The clamps are not making a good
connection.
The fuse is bad.
For information about troubleshooting,
contact customer service for assistance:
services@schumacherelectric.com
www.batterychargers.com
• 14 •
SOLUTION
No problem; this is normal.
The Green LED will be solid
when the charger is checking
the condition of the battery. This
is normal.
Reset the charger by briefly
unplugging it.
You need a charger with a higher
amp rate.
Check for poor connection at
battery and frame.
Replace the in-line fuse for the
ring connector.
to 5:00
CST
am
pm
Publicidad
