Publicidad
Idiomas disponibles
Idiomas disponibles
Long-term storage(30 days or more)
Do not store in sealed locations filled with fuel gas, or close to naked flames or sparks.
You could cause a fire.
When storing the product for long periods of time (30 days or
more), ensure that the following preparations for storage are
carried out.
1.
Store unit in a dry, dust free place, out of the reach of chil-
dren and other unauthorized persons.
2.
Drain or take out remaining chemical from the tank. Clean
inside of chemical tank, shutter and discharge lines.
3.
Remove accumulation of grease, oil, dirt and debris from
exterior of unit.
4.
Perform all periodic lubrication and services that are re-
quired.
5.
Tighten all the screws, bolts and nuts.
6.
Drain the fuel tank completely and pull the starter grip sev-
eral times to remove fuel from the carburettor.
Maintenance and care
WARNING
7.
Remove the spark plug and pour around 10 mL of fresh,
clean, two-stroke engine oil into the cylinder through the
spark plug hole.
8.
Place a clean cloth over the spark plug hole.
9.
Pull the starter grip 2 or 3 times to distribute the oil inside
the engine.
10. Observe the piston location through the spark plug hole.
Pull the starter grip slowly until the piston reaches the top
of its travel and leave it there.
11. Install the spark plug (do not connect ignition cable).
12. Remove pipe assembly from unit.
19
Publicidad
