Contents of Box:
•
Trimmer
•
Parts bag containing:
•
Manual
•
Engine manual
•
Safety goggles
•
Bottle of engine oil
•
2 sets of .155 trimmer line
•
Cable Clip
Tools Required:
•
½" wrench
Installation of handles:
•
Remove loose fasteners from lower handles.
•
Pivot handles up and align lower hole in handles with hole on trimmer frame. Install
hardware removed in previous step. Snug, but do not tighten bolts.
•
Pivot upper handles to fit the lower handles. Tighten knobs.
•
Adjust handles for comfortable operation.
•
Tighten all bolts.
Handles may be adjusted up and down and in and out for comfortable operation.
Installation Of Wheels
Refer to Page 12 for illustration.
•
Slide axle through the mounting plates.
•
Install Conical springs with the large diameter side against the Axle Plate.
•
Install Spring Retainer against the conical spring.
•
Slip wheel on one side and install Cotter Pin.
•
Bend cotter pin over to prevent it from falling out.
•
Push the Axle completely over to the other side.
•
Install the second wheel and insert cotter pin and bend. Some compression of the
conical springs is necessary .
Assembly
6
Handle Adjustment