Publicidad
Idiomas disponibles
Idiomas disponibles
Start Up
Battery use
The battery is shipped with NO CHARGE. It is necessary to charge the battery 6 hours before being able to use it for the first
time. Subsequent load times are performed in about 60 minutes. A normal charging temperature is from 32 °F to 113 °F
Out of this level the charge gets interrupted until reaching the right temperature. A normal temperature for discharge / work
is from 32 °F to 167 °F If 167 °F are exceeded, the electronic control with shut down the tool energy until the temperature
reaches the optimum temperature level. When during work the battery is below the regular voltage, the tool stops
functioning. Between charges, give the charger 15 minutes rest. In hot temperatures or after a long job the battery might get
too hot to be recharged. Allow the battery to cool down before trying to charge it again.
Bits or adaptors assembly
• Using one hand, hold firmly the handle and with your
other hand loosen the base turning in a counterclockwise
direction.
• Insert the bit until it stops or remove it whichever the
situation.
• Turn the base clockwise to fasten the bit.
Direction of rotation
• To bore and screw release the switch and and press the direction button on
the side where marks point towards the chuck.
• To reverse the turn, and unscrew press it on the other side.
• The drill switch will get blocked if the button sits in the middle.
CAUTION
• The first time you turn on the drill and after reversing
rotation you might hear a click. This in normal and does not represent a
problem.
CAUTION
• To prevent damaging the tool, never reverse the
rotation direction while the drill is running.
Speed selection
• The two speeds in the drill work in a similar manner to those
used in cars.
• Low speed (1) will give a lot of torque (torsion power). Use this
speed when starting to drill large orifices, be it wood or metal. This
will prevent the bit to get stuck.
• High speed (2) has a reduced torque but lets the drill operate
with higher revolutions per minute, that make the tool when in
the drill function to bore faster lean metal or wood.
Torque Adjust
• To select the desired torque level to screw drive, turn the torque
regulator until it matches the corresponding number with the upper mark:
From 1 to 4 for small screws,
From 5 to 9 for screws on soft materials,
From 10 to 15 for screws on soft and hard material.
• To bore metal, wood or plastic turn the torque regulator into the
CORDLESS DRILL (
) position.
CAUTION
• The torque level necessary depends on the type of
screw to be used and the material onto which you are working. If in
doubt use a lower torque and increase gradually until reaching the right
one. An adequate torque prevents damaging the tool.
Chuck
base
Forward
Reverse
Torque
regulator
ENGLISH
7
Publicidad
