Manuales relacionados para Truper TALI-20A
Resumen de contenidos para Truper TALI-20A
- Página 1 Manual Cordless drill / driver 20 V 1/2” Chuck Applies for: Code Model 18154 TALI-20A TALI-20A Read this manual thoroughly CAUTION before using the tool.
- Página 2 Start Up Keep this manual for future references. Trouble shooting The illustrations in this manual are for reference Maintenance only. They might be different from the real tool. Environmental Protection Notes Authorized Service Centers Warranty Policy TALI-20A ENGLISH...
- Página 3 Technical Data TALI-20A Code 18154 Description Cordless drill / driver Chuck 1/2” keyless Voltage 20 V Speed Position 1: 0 - 350 RPM Position 2: 0 - 1 400 RPM Rotation Forward - Reverse Torque 15 + 1 function Boring capacity Wood: 1”...
- Página 4 General power tool safety warnings WARNING! Read carefully all safety warnings and instruction listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
- Página 5 Battery and Charger Before operating the tool DANGER • Use only the Truper charger included to • Take your time to assess the job to be done and double charge the battery. Using a different charger may cause fire check you are paying attention to the necessary caution or injury hazard.
- Página 6 Parts Keyless Torque Speed chuck regulator selector Double Battery level indicator light Rotation direction button and switch lock Handle Battery charger Switch Battery release button Charge Battery indicator connection teeth Battery Belt clip Start Up Battery charge 1. Plug in the charger in a 127 V~power outlet. (Green charging indicator light will turn on).
- Página 7 Start Up Battery use The battery is shipped with NO CHARGE. It is necessary to charge at full capacity before being able to use it for the first time. Subsequent load times are performed in about 60 minutes. A normal charging temperature is from 32 °F to 113 °F Out of this level the charge gets interrupted until reaching the right temperature.
- Página 8 Start Up Turn On and operation control • The switch allows selecting the adequate speed for each job. The more you push the switch the fastest the drill will run. • The switch is also built with a braking function. When releasing the trigger, the drill will immediately stop and you LED light is ON while the switch is pushed...
- Página 9 Troubleshooting Problem Cause Solution The drill looses • Low battery. • Charge the battery. efficiency. The trigger cannot be • The direction rotation button is in the blocking • Move the direction button into the rotate or reverse pushed. position. position.
- Página 10 Notes ENGLISH...
- Página 11 In the event of any problem contacting a Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-8737 to get information about the nearest Service Center. AGUASCALIENTES DE TODO PARA LA CONSTRUCCIÓN...
- Página 12 . Transportation costs resulting from compliance of this warranty will be covered by For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257 Stamp of the business.