Publicidad
11
Appliance does not spin
12
Emptying
water
drum
13
Laundry
not
spun
14
Traces of detergent on
laundry
15
Washing results unsatis-
factory
ERROR DISPLAY
In case of a malfunction, the appliance will identify the problem by showing an error code on
the display.
Error code
For all the other error codes displayed, cut off the electricity supply, turn off the water tap and
contact your nearest Service Centre.
Anti-imbalance safety device tripped because laundry not evenly
distributed in drum. If laundry is still wet at end of cycle, rearrange
it in the drum by hand and repeat spin programme only.
from
In the event of a power blackout or appliance failure, the water can
be removed from the drum using the emergency procedure.
properly
Large items screwed up and not evenly distributed within drum.
Always wash a mix of large and small items.
Many phosphate-free detergents contain substances with low wa-
ter solubility.
Select Rinse programme or brush the laundry.
-
Probably too little detergent or unsuitable detergent used
-
Difficult stains not dealt with before washing
-
Correct temperature not set
-
Basket overloaded.
Door not properly closed. Try reclosing.
Aqua stop device tripped. Cut off power supply, turn off water tap and
contact nearest service centre.
Water not taken in for washing. See point 2 in troubleshooting table.
Water not pumped out. See point 4 in troubleshooting table.
Key to problem
EN
25
Publicidad
