Publicidad
Idiomas disponibles
Idiomas disponibles
GETTING STARTED
1
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display
shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB"
1
Press the volume knob.
[YES] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
2
Set the clock
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [CLOCK], then press the knob.
3
Turn the volume knob to select [CLOCK ADJUST], then press the knob.
4
Turn the volume knob to make the settings, then press the
knob.
Day Hour Minute
5
Turn the volume knob to select [CLOCK FORMAT], then press the knob.
6
Turn the volume knob to select [12H] or [24H], then press the knob.
7
Press and hold
to exit.
To return to the previous setting item or hierarchy, press
While in clock display screen...
Press and hold DISP SCRL to enter clock adjustment mode
directly.
4
Then, perform step
above to set the clock.
4
3
Set the initial settings
1
Press B SRC to enter STANDBY.
2
Press the volume knob to enter [FUNCTION].
3
Turn the volume knob to make a selection (see the following table), then
press the knob.
4
Press and hold
To return to the previous setting item or hierarchy, press
AUDIO CONTROL
SWITCH
REAR/ SUB-W: Selects whether rear speakers or a subwoofer are connected to
PREOUT
the line out terminals on the rear (through an external amplifier).
SP SELECT
OFF/ 5/4/ 6 × 9/6/ OEM: Selects according to the speaker size (5 inches or
4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum performance.
TUNER SETTING
PRESET TYPE
NORMAL: Memorizes one station for each preset button in each band
(FM1/ FM2/ FM3/ AM). ; MIX: Memorizes one station for each preset button,
regardless of the selected band.
SYSTEM
KEY BEEP
ON: Activates the keypress tone. ; OFF: Deactivates.
SOURCE SELECT
PANDORA SRC ON: Enables PANDORA in source selection. ; OFF: Disables. ( 8)
IHEART SRC
ON: Enables IHEARTRADIO in source selection. ; OFF: Disables. ( 9)
.
BUILT-IN AUX
ON: Enables AUX in source selection. ; OFF: Disables. ( 8)
F/W UPDATE
UPDATE SYSTEM
F/W UP xx.xx YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
to exit.
.
Default: XX
Publicidad
